2.1.10.1.2.  Combination views
2.1.10.1.2.1.  Render mode
Prev  Next
2.1.10.1.2.1.  Render mode

You can change the appearance of the derivatives in the list field under Render mode.

Choose one of the following options in the list field:

  • Line representation [Line view]:

    Line display [Line view]

    Line display [Line view]

  • Lines + shaded representation [Lines + shaded view]:

    Lines + shaded display [Lines + shaded view]

    Lines + shaded display [Lines + shaded view]

    Combination of line display and shaded display

    Advantage: Visually more appealing than the line display

  • Shaded view [Shaded View]:

    Shaded display [Shaded view]

    Shaded display [Shaded view]

    Here a gridded image is displayed, into a 2-D derivation. The derivation is only created if an export to the CAD system follows.

    Advantages:

    • Optically more attractive than line display

    • Very rapid display, also with complex parts

    [Note]Note

    This render mode is also used to create the 3D data sheet.[97] See Section 2.1.9.4.4, “Export PDF datasheet ” data sheet. This is where the speed advantage comes into its own.



[97] This is also the case with PARTcommunity

Prev Up Next
2.1.10.1.2.  Combination views  Home 2.1.10.1.2.2.  Scaling and paper formats