4.7.3.1.  Roles: General " tab page
4.7.3.1.10.  Catalogs to be suppressed / Show only these catalogs - plinkgroups.cfg -> Block [role name] -> Key "HIDELIST" / "EXCLUSIVELIST"
Prev  Next
4.7.3.1.10.  Catalogs to be suppressed / Show only these catalogs - plinkgroups.cfg -> Block [role name] -> Key "HIDELIST" / "EXCLUSIVELIST"

In PARTadmin it can be defined role-based which catalogs should be displayed.

There are two ways to do this:

  • Catalogs to be suppressed [Catalogs to suppress]: Hide certain catalogs or directories for a specific role.

  • Only display these catalogs [Show only these catalogs]: Exclusively display certain catalogs or directories for a specific role. With this method, you are on the safe side after a new catalog installation that the catalog is not automatically displayed initially, but you must actively intervene to make it visible.

Setting in user interface under PARTadmin -> Category Roles -> Tab General -> Catalogs to be suppressed [Catalogs to suppress] / Show only these catalogs

Enter the catalogs/directories to be hidden or exclusively shown in the key, separated by commas.

[Note]Note

The spelling of the catalog name must exactly match the name under $CADENAS/23d-libs/{catalogname} must match exactly. Always use lower case letters.

Setting in configuration file: $CADENAS_SETUP/plinkgroups.cfg-> Block [role name] -> Key "HIDELIST" or key "EXCLUSIVELIST"

Example:

  • Listing of catalogs

    [Role_name]
HIDELIST=catalog1,catalog2,norm

  • Listing of paths to subdirectories

    [Role_name]
HIDELIST=catalog1/parts/a,norm/en

Prev Up Next
4.7.3.1.9.  Release certain directories for export - plinkgroups.cfg -> Block [Role_name] -> Key "EXPPRJTAB" / plinktemplates.cfg  Home 4.7.3.2.  Roles: PDM" tab page