Manuals - PARTsolutions

Chapter 34. V9.05 34.12. PDM Agile - Support for "useplmtable2" (9.05 SP0)
Prev	Next

34.12. PDM Agile - Support for "useplmtable2" (9.05 SP0)

Configuration file: ifagile.cfg

As of V9.05 the key useplmtable2 has been added.^[209]

Caution

	Caution
If `usePLMTable2` is set on 0 and `forceDownload` is also set on 0, then `checkoutIncludesSubitems` should be set on 1, because otherwise subparts of an assembly (which is already in Agile and in the pool directory) are overwritten. Files names of subparts are not known and therefor it is not possible to check, whether there already is a part in the pool directory.

If usePLMTable2 is set on 0 and forceDownload is also set on 0, then checkoutIncludesSubitems should be set on 1, because otherwise subparts of an assembly (which is already in Agile and in the pool directory) are overwritten.

Files names of subparts are not known and therefor it is not possible to check, whether there already is a part in the pool directory.

Note

	Note
If `forceDownload` is set on 0, then the following applies: No older files are deleted on the disk. If there already is a file, it is used.

If forceDownload is set on 0, then the following applies:

No older files are deleted on the disk. If there already is a file, it is used.

^[209]#27647

Prev	Up	Next
34.. PDMWorks Enterprise interface - New keys added (9.05 SP0)	Home	34.13. Teamcenter - Inv \| ProE/Creo \| SE \| NX - functions concerning "TargetFolder" (9.05 SP0)