Chapter 2.  Open PARTsolutions from CAD systems
2.2. Integration of the PARTsolutions interface
Prev  Next

2.2. Integration of the PARTsolutions interface

The PARTsolutions interface is integrated automatically if your CAD interface has been selected in the corresponding section of the PARTsolutions installation.

The interface is then saved under ... $CADENAS \iface\ $CADENAS saved.

It is possible that CAD specific settings must still be made in order to make the PARTsolutions menu visible.

The configuration files are located under $CADENAS_SETUP/if"cad_kurzbezeichnung".cfg.[1]

Under PARTadmin -> CAD integration category, you can see whether interfaces are installed and whether they are activated or deactivated, and also activate/deactivate them manually. See Section 1.3.2, “ CAD integration ” in PARTsolutions Administration - Manual .



[1] Detailed information on this can be found at Chapter 2, PARTsolutions - CAD Integration - Administration in PARTsolutions Administration - Manual .

Prev Up Next
2.1. Information on provided interfaces of the current PARTsolutions version Home 2.3. Function test of the PARTsolutions interface - activation / deactivation