For example, if a matching counterpart for a hole is searched, it may be advantageous not to include the "length" attribute. Fitting connectors could possibly have different lengths.

In such a case use search template Partial search V2 (No length).

	Note
	Differentiation to Topology search: If it is only about a single hole, also Topology search using tolerance could be used. However, if it is about two or more holes in a certain distance or a pattern, for example, in this case you have to use the Partial search.

Example:

When searching a socket for a connector, you would mark the pins. But the length of the holes in the socket could be different. In such a case you would use this option.