The key VARORDER in the section [PARTdataManager] is omitted without substitution (and the respective field in the user interface as well).

($CADENAS_SETUP/plinkcommon.cfg)

Now the column sequence is defined in the key VARUSED, in the respective role section, thus is role dependent.

($CADENAS_SETUP/plinkgroups.cfg)

In the user interface the setting is performed under PARTadmin -> Category -> PARTsolutions -> ERP environment -> Roles -> Columns to be displayed

Columns to be displayed

Note In case that some ERP columns are to be displayed at the top and others at the bottom - in other words the geometric data somewhere in the middle, then please use the following syntax: ERP_PDM_NUMBER,MAT_NAME, ... ,DESCRIPTION At the position of „...“ the geometric columns are shown.