3.1.13.1.  Purchineering
3.1.13.1.10. Icons in "Make or Buy", "Find suppliers", "Cost mockup", "Unmachined / Finished part report"
Prev  Next
3.1.13.1.10. Icons in "Make or Buy", "Find suppliers", "Cost mockup", "Unmachined / Finished part report"
3.1.13.1.10.1. Part comparison

Via icons beneath each part you can perform the following actions:

Icon Tooltip at mouse over the icon Action
Go to directory in catalog index

The project is marked in PARTdataManager, in the Part selection, in the index tree.

[Note]Note

You can configure whether the dialog box shall be minimized after execution of the command. On this see under Section 3.3.14.1, “General”.

Open project

The project is opened in PARTdataManager, in the 3D preview.

[Note]Note

You can configure whether the dialog box shall be minimized after execution of the command. On this see under Section 3.3.14.1, “General”.

Compare to search-part

The search part and the result part are loaded in PARTdataManager, in the Part comparison.

See following figures.

A detailed description is found under Section 3.1.6.10, “ Part comparison ”.

Compare with all results

The search part and all found parts are loaded in PARTdataManager, in the Part comparison (max. 10).

See following figures.

A detailed description is found under Section 3.1.6.10, “ Part comparison ”.

Information on the buttons Search part..., Print..., Open report folder (HTML), Export is found under Section 3.1.13.1.11, “Buttons ”.

Prev Up Next
3.1.13.1.9. Setting options for "Make or Buy", "Find suppliers", "Cost mockup" Home 3.1.13.1.10.1.  Part comparison