Chapter 2.  Open PARTsolutions from CAD systems
2.3. Function check of the PARTsolutions interface
Prev  Next

2.3. Function check of the PARTsolutions interface

Are the dialogs for interaction available?

Should the PARTsolutions menu not be available, you may have forgotten to integrate the respective interface during the PARTsolutions installation.

  • Check whether the interface was saved under "$CADENAS\iface\"cadname".

  • Check if in PARTadmin, under CAD integration, the desired Integration is active.

    Example: The integration of "Creo 5.0 Parametric 64 Bit" is active.

    Example: The integration of "Creo 5.0 Parametric 64 Bit" is active.

Prev Up Next
2.2. Integrating the PARTsolutions interface  Home 2.4. Opening the interface