Note
	As of V10 the marking of parts/lines to be avoided happens by an own variable CNSAVOID in the characteristic attribute table. Control by the configuration file $CADENAS_DATA/datasetup/avoid_parts.cfg is not used anymore!

In some Standards certain sizes are marked as to be avoided sometimes.

In order to show or hide these parts use the button Hide Lines to Avoid in PARTdataManager. By default, the button is deactivated, so that all project lines are shown. When activating the button, lines marked with the icon are hidden.

Hide Lines to Avoid: deactivated

Hide Lines to Avoid: activated

In order to provide the functionality proceed as follows:

	Tip
	The following markup of parts complement each other: Replaced parts / replacement parts (see Section 1.7.3.3, “ replace_std.cfg ” in PARTsolutions - Administration Manual) Parts to be avoided (description in the section in hand) Parts with End-of-Life date (see Section 5.9.2.12, “Menu item Expiration date (End of Life) ”)