2.5.4.2. Additional information
2.5.4.2.1. Activating the PARTsolutions interface
Prev  Next
2.5.4.2.1. Activating the PARTsolutions interface

  1. Application -> Modules

    Open the Modules dialog box and select Add-Ins.

  2. Set a checkmark at PARTsolutions

  3. Click Close, if you want to activate one time only

    or

    click on Start..., if you want to activate permanently.

    Add PARTsolutions to the startup sequence.

    [Note]Note

    The STL module has to be part of the startup sequence. This is required for inserting parts into the User library.

    [Note]Note

    ModelManager / SAP has to be before PARTsolutions in the startup sequence!

Prev Up Next
2.5.4.2. Additional information Home 2.5.4.2.2.  Insert 3D - PARTsolutions placement dialog