2.3.6.1. Block [CreationOptions(is3d)]
2.3.6.1.3.  Key "TemplateFile" - Adjust templates
Prev  Next
2.3.6.1.3.  Key "TemplateFile" - Adjust templates

The templates can be adjusted separately for the following groups:

  • Assembly, Inch

  • Part, Inch

  • Assembly, MM

  • Part, MM

Adjusting the path: The templates may not be in the default storage location, but somewhere in the network. In this case, the path in the TemplateFile key must be adjusted accordingly.

Example:

TemplateFile(is3dpart,ismmdoc)=?"Z:\\Inventor\\Vorlagen\\Norm (mm).ipt"
TemplateFile(is3dasm,ismmdoc)=? "Z:\\Inventor\\Vorlagen\\Norm (mm).iam"

Example for UNC path:

\\\\server001\\Inventor\\Vorlagen\\Norm (mm).ipt

If necessary, also adjust the name of the templates. For example, the default is Norm (mm).iam and Norm (mm).ipt.

Prev Up Next
2.3.6.1.2.  Key "FileName" - Define structure of document name Home 2.3.6.1.4.  Key "CreateIMates"