2.3. CAD specific information
2.3.5.  CoCreate Modeling Integration - Administration
Prev  Next

2.3.5.  CoCreate Modeling Integration - Administration

2.3.5.1. Block [CreationOptions(is3d)] - How to setup?
2.3.5.1.1. Key "FileName"
2.3.5.1.2. Key "DistributeMass"
2.3.5.1.3. Key "EnhancedPhysicalProperties" - Calculation of Physical Properties
2.3.5.2. Block [UI] - Adjust menus and toolbars
2.3.5.3. Block [INTERFACE]
2.3.5.3.1. Key "denied_value_char"
2.3.5.3.2. Key "replace_char" - Replacement of characters
2.3.5.4. Block [AttributeMapping(is3d)]
2.3.5.4.1. Key "Attr_CopyFrom_01"
2.3.5.5. Block [CadDocumentAttributes]
2.3.5.6. Modelmanager - Configuration
2.3.5.7. User documentation

In the configuration file ifosdm.cfg you will find all settings for PARTsolutions - CoCreate Modeling | Creo Elements/Direct Modeling Integration.

The most important information on the individual blocks and keys can be found in the configuration files themselves.

Below you will find more detailed information on individual blocks and keys.

Syntax and basic concepts are explained at Section 2.2, “Cross-CAD information ”.

[Note]Note

Changes to configuration files should only be made by experienced users or CADENAS consultants.

Prev Up Next
2.3.4.7. Commands to adjust behavior/visibility of PARTsolutions interface menu and workbenches  Home 2.3.5.1.  Block [CreationOptions(is3d)] - How to setup?